Siemens SINUMERIK 802D

Manual mode
5.3 MDA mode (manual input) "Position" operating area
Cylindrical grinding
76 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
– "Circular"
Figure 5-11 Circular
You teach in an intermediate point and an end point for a circle.
Operation in the "Rapid traverse", "Linear" and "Circular" dialogs
1. Use the axis keys to traverse the axes to the required position that you want to
add/change in the part program.
2. Click "Insert transfer" to add a new part program block. The new part program block will
be added in front of the block selected with the cursor.
3. Click "Change transfer" to change the selected part program block.
Use "<<Back" to return to the "Teach In" start screen.
Use "Exit Teach In" (see "Start screen") to leave the "Teach In" submode.
&LUFXODU
;
=
,QVHUW
WUDQVIHU
&KDQJH
WUDQVIHU

%DFN
([LW
7HDFK,Q