Siemens SINUMERIK 808D ADVANCED - Page 481

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
481
GEAR_STEP_MAX_VELO_LIMIT
MD 35130, 267
GEAR_STEP_MAX_VELO2
MD 35112, 266
GEAR_STEP_MIN_VELO
MD 35120, 266
GEAR_STEP_MIN_VELO_LIMIT
MD 35140, 269
GEAR_STEP_MIN_VELO2
MD 35122, 267
GEAR_STEP_PC_MAX_VELO_LIMIT
MD 35135, 268
GEAR_STEP_POSCTRL_ACCEL
MD 35210, 271
GEAR_STEP_POSCTRL_ACCEL2
MD 35212, 271
GEAR_STEP_SPEEDCTRL_ACCEL
MD 35200, 271
GEAR_STEP_USED_IN_AXISMODE
MD 35014, 259
General selection/status signals from HMI, 432
General selection/status signals from the MMC, 337, 338
General selection/status signals to HMI, 433
General signals from NCK, 437
General signals to NCK, 436
H
H functions from NCK channel, 436
HANDWH_GEOAX_MAX_INCR_SIZE
MD 20620, 141
HANDWH_IMP_PER_LATCH
MD 11320, 66
HANDWH_MAX_INCR_SIZE
MD 32080, 216
HANDWH_MAX_INCR_VELO_SIZE
MD 32082, 216
HANDWH_REVERSE
MD 11310, 65
HANDWH_STOP_COND
MD 32084, 217
HANDWH_TRUE_DISTANCE
MD 11346, 67
HANDWH_VELO_OVERLAY_FACTOR
MD 32090, 218
HEX values, 453
HW_ASSIGN_DIG_FASTOUT
MD 10368, 34
HW_SERIAL_NUMBER
MD 18030, 83
Siemens Controls