4.5.7 This is how you remove the MCP 483C PN
Overview
The activities that must be taken into account when replacing a machine control panel are
subsequently described.
If the machine control panel has a hardware defect, then it must be replaced by an identical
replacement part.
Preconditions:
● The module is defective and must be replaced.
● The control cabinet is in a no-voltage condition, all of the connectors and cables are labeled.
Service cases - hardware
4.5 Machine control panels
Software and hardware
100 Service Manual, 08/2018, 6FC5397-5DP40-6BA1
To Next Page
Loading...
