5. Attach the Torx-slotted screw to the fan cover.
6. Install the front panel and tighten the front screws.
(see Chapter: This is how you remove the front panel (Page 145) )
4.10.12 This is how you install the external fan
Preparation
The external fan unit is always installed above the S120 Combi in the control cabinet.
Make an installation cut-out in the control cabinet panel. The position depends on the
installation cut-out for the S120 Combi (see Chapter:How to mount an S120 Combi Power
Module (Page 142)).
Mounting accessories
Number Designation Specification
5 Self-clinching flush head
studs
M4, steel, strength class 8.8, zinc-plated, length: 15 mm
5 Nut M4, steel, strength class 8, zinc-plated
Service cases - hardware
4.10 SINAMICS S120 Combi
Software and hardware
158 Service Manual, 08/2018, 6FC5397-5DP40-6BA1
To Next Page
Loading...
