Siemens SINUMERIK 828D Series - Replacing the Front Cover; This Is How You Remove the Front Cover

4.4 Replacing the front cover
4.4.1 This is how you remove the front cover
Precondition
You must first remove the PPU before you remove the front cover, see This is how you remove
the PPU (Page 85).
Removing the front cover
Procedure:
1. Open the front cover.
2. Press the holding pins of the front cover through the openings at the rear. The tool that you
use may have a maximum width of 2 mm.
3. Remove the front cover.
Service cases - hardware
4.4 Replacing the front cover
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1 91