Inserting the system CompactFlash Card
Note
When inserting the system CompactFlash Card, carefully ensure that neither the screw nor
the system CompactFlash Card falls into the PPU or the machine.
Procedure:
1. Release the screw (M3), and swing the metal cover to the side to remove it.
2. Gently insert the system CompactFlash Card into the slot until it clicks into place.
3. First, guide the metal cover at the rear into the rabbet and then tilt it into the end position.
4. Attach the metal cover to the housing using the screw.
Service cases - hardware
4.3 Replacing the system CompactFlash Card
Software and hardware
90 Service Manual, 08/2018, 6FC5397-5DP40-6BA1
To Next Page
Loading...
