Siemens SINUMERIK 828D Series - NX10.3; NX15.3 Connections; This Is How You Remove the NX10.3; NX15.3

4.7.2 NX10.3 / NX15.3 connections
Connections
;;
'5,9(&/L4LQWHUIDFHV
;
'LJLWDOLQSXWVRXWSXWV
;
(OHFWURQLFVSRZHUVXSSO\
5(6(7EXWWRQ
777
0HDVXULQJ
VRFNHWV
*URXQGFRQQHFWLRQ
01P
3URWHFWLYHFRQGXFWRU
FRQQHFWLRQ
01P
;
6HULDOLQWHUIDFH
QRIXQFWLRQ
7\SHSODWH
/('V
6KLHOGFRQQHFWLRQ
;
;
5'<
'3
Figure 4-24 NX10.3 / NX15.3 connections
4.7.3 This is how you remove the NX10.3 / NX15.3
Preconditions
The activities that are required when replacing an NX10.3 / NX15.3 are subsequently
described.
If the NX10.3 / NX15.3 has a hardware defect, then it must be replaced by an identical module.
Service cases - hardware
4.7 Expansion modules NX10.3 / NX15.3
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1 119