Siemens SINUMERIK 828D Series User Manual

View from the top
+HDWVLQN
6KLHOGFRQQHFWLRQ(3
WHUPLQDO
(3WHUPLQDO
'5,9(&/L4ZLWK
JXLGHIUDPH
9SOXJFRQQHFWRU
;
;;
;;
EP terminal The shield support is included in the accessories pack (Weidmüller, type KLBÜ 3-8 SC).
View from below
+HDWVLQN
%UDNHFRQQHFWLRQ
6KLHOGFRQQHFWLQJ
WHUPLQDOV
;
4.10.4 How to mount an S120 Combi Power Module
Precondition
The reinforcement plates are installed in order to mount an S120 Combi Power Module.
Service cases - hardware
4.10 SINAMICS S120 Combi
Software and hardware
142 Service Manual, 08/2018, 6FC5397-5DP40-6BA1

Siemens SINUMERIK 828D Series Specifications

General

Display	10.4" TFT color display
Operating System	Embedded Linux
Power Supply	24V DC
Protection Class	IP65 (front), IP20 (rear)
Control Unit Type	CNC
Interfaces	Ethernet, USB, RS232
Programming	ShopMill, ShopTurn, G-code