Siemens SINUMERIK 828D Series User Manual

4.4.2 This is how you install the front cover
Installing the front cover
Procedure:
1. Insert the springs and pins into the front cover.
Pin
Cover
Spring
Spring
Pin
2. Press in the pins and mount the front cover. The pins must snap into the PPU housing.
After you have installed the front cover, you can also possibly reinstall the PPU, see This is
how you install the PPU (Page 86).
Service cases - hardware
4.4 Replacing the front cover
Software and hardware
92 Service Manual, 08/2018, 6FC5397-5DP40-6BA1

Siemens SINUMERIK 828D Series Specifications

General

Display	10.4" TFT color display
Operating System	Embedded Linux
Power Supply	24V DC
Protection Class	IP65 (front), IP20 (rear)
Control Unit Type	CNC
Interfaces	Ethernet, USB, RS232
Programming	ShopMill, ShopTurn, G-code