Removing
① Slot for Emergency Stop button or spindle override
② X10 Power supply interface
③ X60 Handwheel connection
④ X61 Reserved
⑤ S1 Switch for setting the handwheel signal type
⑥ S2 Switch for setting the MCP address
⑦ LED
⑧ Ethernet cable strain relief
⑨ X21 Port 2: PLC I/O interfaces based on PROFINET
⑩ X20 Port 1: PLC I/O interfaces based on PROFINET
⑪ Equipotential bonding
⑫ Feedrate override
⑬ Customer-specific inputs and outputs
Figure 4-14 MCP 310C PN rear side
Procedure:
1. Switch-off the control: Completely switch off the system. Check that the system is in a no-
voltage condition and is locked-out so that it cannot be switched on again without the
appropriate authorization.
2. Access the operator panel or control cabinet in which the machine control panel is located.
3. Using a multimeter, check the X10 power supply to ensure that the system really is in a no-
voltage condition.
Service cases - hardware
4.5 Machine control panels
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1 105
To Next Page
Loading...
