Siemens SINUMERIK 828D Series User Manual

3. Using a multimeter (set the measuring range to 1000 V DC) at the points DCP/DCN, check
that the DC link voltage is in a no-voltage condition.
Only continue with the work when it has been absolutely ensured that no voltage is present
(a no-voltage condition has been established).
'&3
-XPSHUSOXJ
'&
4. Withdraw the red 24 V jumper plug.
5. Release the Torx screws of the DC link.
7RU[7
7RU[7
Service cases - hardware
4.13 Double Motor Modules
Software and hardware
184 Service Manual, 08/2018, 6FC5397-5DP40-6BA1

Siemens SINUMERIK 828D Series Specifications

General

Display	10.4" TFT color display
Operating System	Embedded Linux
Power Supply	24V DC
Protection Class	IP65 (front), IP20 (rear)
Control Unit Type	CNC
Interfaces	Ethernet, USB, RS232
Programming	ShopMill, ShopTurn, G-code