Siemens SINUMERIK 828D Service Manual

Service cases - software
3.7 Enter the final end user data (EUNA)
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0
67
3. Press the "Logbook" softkey.
4. Press the "New entry" softkey in order to make an entry in the logbook.
Complete the fields for the new logbook entry:
5. Press the "OK" softkey to save an entry in the logbook.
For the following activities, two additional softkeys are available, which generate pre-
configured logbook entries:
1st commissioning completed
2nd commissioning completed
NOTICE
Once saved, data can no longer be changed.

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash