Siemens SINUMERIK 828D Service Manual

Service cases - software
3.7 Enter the final end user data (EUNA)
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0
69
The data are pre-assigned so that a change is not necessary.
The "Name" text field is pre-assigned as follows:
<Machine name/Number>+<Number of the CompactFlash Card>
You now have the opportunity of changing this name.
You can enter a comment in the "Comments" text field.
Select the following options:
– "Version data (.TXT)": Output of the version data in the text format
– "Configuration data (.XML)": All information about the machine identity
5. Press the "OK" softkey to start saving the data.
3.7.4 This is how you send the end user final destination data
Overview
The configuration file (address data, logbook data, version data) of the control can be sent to
the EUNA database (End User Notification Administration) via an Internet connection.

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash