Service cases - software
3.7 Enter the final end user data (EUNA)
Hardware and Software
66 Service Manual, 03/2011, 6FC5397-5DP40-0BA0
Note
Contact data
Using the "Import data" softkey, templates with contact data can be imported to simplify
data entry; these templates are available through Siemens sales partners.
3.7.2 This is how you make a new entry in the logbook
Generating a new logbook entry
In order to log service and diagnostic procedures at the machine, make an entry in the
machine logbook. The activities performed are logged here after each service call.
To make a logbook entry, proceed as follows:
1. Select the "Diagnostics" operating area using the following key:
2. Press the "Version" softkey.
To Next Page
Loading...
