Service cases - hardware
4.4 Machine control panels
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0
93
4.4.2 This is how you remove the MCP 310C PN
Overview
The activities that must be taken into account when replacing a machine control panel are
subsequently described.
If the machine control panel has a hardware defect, then it must be replaced by an identical
replacement part.
Preconditions:
● The module is defective and must be replaced.
● The control cabinet is in a no-voltage condition, all of the connectors and cables are
labeled.
To Next Page
Loading...
