Siemens SINUMERIK 828D Service Manual

Service cases - software
3.7 Enter the final end user data (EUNA)
Hardware and Software
70 Service Manual, 03/2011, 6FC5397-5DP40-0BA0
This means that the service organization has the possibility of obtaining a profile about the
history of the control without having to go to the machine. Therefore, service can be more
effectively carried-out as all of the relevant information is available.
Sending the end user final destination data
Preconditions:
● The commissioning status is saved in the logbook.
● The machine identity has been entered/updated in the machine.
● The machine identity was saved and is available on the PC/PG.
● The PC/PG is connected with the Internet.
Please proceed as follows:
1. Open the Internet Browser on your PC/PG.
2. Connection with EUNA (http://www.siemens.com/sinumerik/register
).
3. Select a language and enter an e-mail address:

Siemens SINUMERIK 828D Specifications

General

Control Type	CNC
Operating System	Windows Embedded
Processor	Intel Atom
Display	10.4" color TFT display
Interfaces	Ethernet, USB
Programming	ShopMill, ShopTurn
Operation Panel Size	10.4"
Protection Class	IP65
PLC Memory	2 MB
Spindle Capacity	4 spindles
Hard Drive	CompactFlash