Siemens SINUMERIK 840D sl - Page 348

7
G Code Program 08/2005
7.2 Executin
g
a G-code
p
ro
g
ram
7
♥ Siemens AG, 2005. All rights reserved
7-348 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
G code program:
Execution
-or-
 Press the softkey or the "Program" key.
-and-
 Position the cursor on the desired G code program.
-and-
Execute
 Press the "Execute" softkey.
-or-
 Press the "Execute" softkey if you are in the "Program" operating
area.
ShopTurn automatically switches to "Machine Auto" mode and loads
the G-code program.
Cycle Start
 Press the "Cycle Start" key.
Execution of the G code program starts on the machine.