Siemens SINUMERIK 840D sl - Page 85

2
08/2005 Setting Up the Machine
2.8 Manual mode
2
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition 2-85
Back to
manual
-and-
 Press the "Back to manual" softkey.
The work offset will be active the next time you press the "Cycle Start"
key.
Setting the unit of
measurement
Jog
 Select the "T, S, M" softkey in "Machine Manual" mode.
 Select the unit of measure.
The unit of measurement will be active in manual mode the next time
you press the "Cycle Start" key.