Siemens SINUMERIK 840D - Page 326

4
Programming with G Code 10.04
4.3 G code editor
4
 Siemens AG, 2004. All rights reserved
4-326 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Jumping to start/end
Continue
>
To
start
To
end
 Select the "Continue" and "To start" or "To end" softkeys.
The beginning or end of the G code program is displayed.
Renumber the G code
blocks
Continue
>
Re-
number >
 Select the "Continue" and "Renumber" softkeys.
 Enter the number of the first block and the increment between
block numbers (e.g. 1, 5, 10).
 Press the "Accept" softkey.
The blocks are renumbered.
You can cancel the numbering again by entering 0 for the increment
or block number.