Siemens SINUMERIK 840Di sl - Page 437

Tables
12.1 List of statements
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
437
Name Meaning Value Description,
comment
Syntax m/s
3
Group
2
CONTDCON
Tabular contour decoding ON
CONTPRON Activate contour preparation
(contour preparation ON)
COS Cosine
(trigon. function)
real
COUPDEF Definition ELG
group/synchronous
spindle group
(couple definition)
String Block change
(software)
response:
NOC: no block-
change control
FINE/COARSE:
block change
on
"synchronism
fine/coarse"
IPOSTOP:
block change in
setpoint-
dependent
termination of
overlaid
movement.
COUPDEF(FS, ...)
COUPDEL Delete ELG group (couple delete) COUPDEL(FS,LS)
COUPOF ELG group/synchronous spindle pair OFF
(couple OFF)
COUPOF(FS,LS,
POS
FS
,POS
LS
)
COUPOFS Deactivating ELG group/synchronized
spindle pair with stop of following spindle
COUPOFS(FS,LS,POS
FS
)
COUPON ELG group/synchronous spindle pair ON
(couple ON)
COUPON(FS,LS,
POS
FS
)
COUPONC Transfer activation of ELG
group/synchronized spindle pair with
previous programming
COUPONC(FS,LS)
COUPRES Reset ELG group
(couple reset)
Programmed
values invalid;
machine data
values valid.
COUPRES(FS,LS)
CP Path movement (continuous path) m 49
CPRECOF
1,6
Programmable contour precision OFF m 39
CPRECON
6
Programmable contour precision ON m 39
CPROT Channel-specific protection zone ON/OFF
CPROTDEF Channel specific protection area definition
CR Circle radius Real, without
sign
s
CROT Rotation of the current
coordinate system.
FRAME Max. parameter
count: 6