Siemens SINUMERIK 840Di sl - Page 442

Tables
12.1 List of statements
Fundamentals
442 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Name Meaning Value Description,
comment
Syntax m/s
3
Group
2
DISR
Distance for repositioning Real, without
sign
s
DITE Thread run-out path Real m
DITS Thread run-in path Real m
DIV Integer division
DL Total tool offset INT m
DRFOF Deactivate the handwheel offsets (DRF) m
DRIVE
7, 9
Velocity-dependent path acceleration m 21
DRIVEA Switch on bent acceleration characteristic
curve for the programmed axes
DYNFINISH Dynamic for smooth-finishing DYNFINISH G1 X10
Y20 Z30 F1000
m 59
DYNNORM Standard dynamic, as previously DYNNORM G1 X10 m 59
DYNPOS Dynamics for positioning mode, tapping DYNPOS G1 X10 Y20
Z30 F...
m 59
DYNROUGH Dynamic for roughing DYNROUGH G1 X10
Y20 Z30 F10000
m 59
DYNSEMIFIN Dynamic for finishing
Technology
G group
DYNSEMIFIN G1 X10
Y20 Z30 F2000
m 59
EAUTO Definition of last spline segment by the last
3 points
(end not a knot)
m 20
EGDEF Definition of an electronic gear
(electronic gear define)
For 1 following
axis with
up to 5 leading
axes
EGDEL Delete coupling definition for the following
axis
(electronic gear delete)
Stops the
preprocessing.
EGOFC Switch off electronic gear continuously
(electronic gear OFF continuous)
EGOFS Switch off electronic gear selectively
(electronic gear OFF selective)
EGON Switch on electronic gear
(Electronic gear ON)
Without
synchronization
.
EGONSYN Switch on electronic gear
(electronic gear ON synchronized)
With
synchronization
.
EGONSYNE Switch on electronic gear, stating
approach mode
(electronic gear ON synchronized)
With
synchronization
.
ELSE Program branch, if IF condition not fulfilled