Tables
12.1 List of statements
Fundamentals
466 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Name Meaning Value Description,
comment
Syntax m/s
3
Group
2
SYNR
The variable is read synchronously, i.e., at
execution time
(synchronous read)
SYNRW The variable is read and written
synchronously, i.e., at execution time
(synchronous read-write)
SYNW The variable is written synchronously, i.e.,
at execution time
(synchronous write)
T Call tool
(only change if specified
in machine data;
otherwise M6 command
necessary)
1, ..., 32 000 Call using T-no.
or tool identifier.
For example, T3 or
T=3,
e.g., T="DRILL"
TAN Tangent (trigon. function) real
TANG Determine tangent for the follow-up from
both specified leading axes
TANGOF Tangent follow-up mode OFF
TANGON Tangent follow-up mode ON
TCARR Request toolholder
(number "m")
Integer m=0: deselect
active
toolholder
TCARR=1
TCOABS
1
Determine tool length components from
the orientation of the current toolholder
m 42
TCOFR Determine tool length components from
the orientation of the active frame
Necessary after
reset, e.g.,
through manual
setting
m 42
TCOFRX Determine tool orientation of an active
frame on selection of tool, tool points in X
direction
Tool
perpendicular to
inclined surface
m 42
TCOFRY Determine tool orientation of an active
frame on selection of tool, tool points in Y
direction
Tool
perpendicular to
inclined surface
m 42
TCOFRZ Determine tool orientation of an active
frame on selection of tool, tool points in Z
direction
Tool
perpendicular to
inclined surface
m 42
THETA Angle of rotation THETA is
always
perpendicular to
the current tool
orientation.
THETA=Value
THETA=AC
THETA=IC
Polynomial for THETA
PO[THT]=(…)
s
TILT
5
Tilt angle real TILT=Value m
To Next Page
Loading...
