Siemens SINUMERIK 840Di sl - Page 467

Tables
12.1 List of statements
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
467
Name Meaning Value Description,
comment
Syntax m/s
3
Group
2
TMOF
Deselect tool monitoring T-no. required
only when the
tool with this
number is not
active.
TMOF (T no.)
TMON Activate tool monitoring T No. = 0:
Deactivate
monitoring for
all tools
TMON (T no.)
TO Defines the end value in a FOR counter
loop
TOFFOF Deactivate on-line tool offset
TOFFON Activate online tool length offset
(Tool offset ON)
Specify a 3D
offset direction.
TOFFON (Z, 25) with
offset direction Z,
offset value 25
TOFRAME Set current programmable frame to tool
coordinate system
m 53
TOFRAMEX X axis parallel to tool direction, secondary
axis Y, Z
m 53
TOFRAMEY Y axis parallel to tool direction, secondary
axis Z, X
m 53
TOFRAMEZ Z axis parallel to tool direction, secondary
axis X, Y
Frame rotation
in tool direction.
m 53
TOLOWER Convert letters of the string into lowercase
TOROTOF Frame rotations in tool direction OFF m 53
TOROT Z axis parallel to tool orientation m 53
TOROTX X axis parallel to tool orientation m 53
TOROTY Y axis parallel to tool orientation m 53
TOROTZ Z axis parallel to tool orientation
Frame rotations
EIN
Rotary
component of
the
programmable
frame
m 53
TOUPPER Convert letters of the string into uppercase
TOWSTD Initial setting value for offsets in tool length m 56
TOWBCS Wear values in basic coordinate system
(BCS)
m 56
TOWKCS Wear values in the coordinate system of
the tool head for kinetic transformation
(differs from MCS by tool rotation)
m 56
TOWMCS Wear data in the machine coordinate
system (MCS)
Inclusion of tool
wear
m 56