Glossary
Control display
The control display becomes visible for devices with a large display after pressing the Control key. The diagram
contains the switching devices to be controlled in the feeder. The control display serves for implementing
switching operations. Specification of this diagram forms part of configuring.
DCF77
The precise official time is determined in Germany by the Physikalisch-Technische Bundesanstalt PTB in Bruns-
wick. The atomic clock unit of the PTB transmits this time via the long-wave time signal transmitter in Main-
flingen near Frankfurt/Main. The emitted time signal can be received within a radius of approx. 1500 km from
Frankfurt/Main.
GOOSE
Generic Object-Oriented Substation Event
Ground
The conductive ground whose electric potential can be set equal to 0 at every point. In the area of grounding
conductors, the ground can have a potential diverging from 0. The term reference ground is also used for
this situation.
Grounding
The grounding is the entirety of all means and measures for grounding.
IEC
International Electrotechnical Commission - International electrotechnical standardization body
Parameterization
Comprehensive term for all setting work on the device. You can set parameters for the protection functions
with DIGSI 5 or sometimes also directly on the device.
PB Client
Process-bus Client. The subscriber of Sampled Measured Values can also be called process-bus client.
RSTP
Rapid Spanning Tree Protocol
SFP
Small Form-Factor Pluggable
SNMP
Simple Network Management Protocol
SIPROTEC 5, Hardware Description, Manual
291
C53000-G5040-C002-M, Edition 12.2021
To Next Page
Loading...
Need help?
General
