Siemens siprotec 7SA522 - Page 564

A Appendix
564
7SA522 Manual
C53000-G1176-C155-3
2948 Sync. Freq. diff. greater than limit
(Sync. fdiff>)
Sync. Check OUT ON
OFF
ON
OFF
* LED BO 41 48 1 Yes
2949 Sync. Angle diff. greater than
limit (Sync. ϕ-diff>)
Sync. Check OUT ON
OFF
ON
OFF
* LED BO 41 49 1 Yes
2951 Synchronism release (to ext. AR)
(Sync. release)
Sync. Check OUT * * * LED BO 41 51 1 Yes
2961 Close command from synchro-
check (Sync.CloseCmd)
Sync. Check OUT * * * LED BO 41 61 1 Yes
2970 Sync. Bus frequency > (fn + 3Hz)
(Sync. f-bus>>)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
2971 Sync. Bus frequency < (fn - 3Hz)
(Sync. f-bus<<)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
2972 Sync. Line frequency > (fn +
3Hz) (Sync. f-line>>)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
2973 Sync. Line frequency < (fn - 3Hz)
(Sync. f-line<<)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
2974 Sync. Bus voltage > Umax
(P.3504) (Sync. U-syn>>)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
2975 Sync. Bus voltage < U> (P.3503)
(Sync. U-syn<<)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
2976 Sync. Line voltage > Umax
(P.3504) (Sync. U-line>>)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
2977 Sync. Line voltage < U> (P.3503)
(Sync. U-line<<)
Sync. Check OUT ON
OFF
ON
OFF
*LED BO
3196 Local relay in Teststate (local
Teststate)
Prot. Interface IntSP ON
OFF
ON * LED FC
TN
BO
3215 Incompatible Firmware Versions
(Wrong Firmware)
Prot. Interface OUT ON * * LED BO
3217 Prot Int 1: Own Datas received
(PI1 Data reflec)
Prot. Interface OUT ON
OFF
**LEDBO
3218 Prot Int 2: Own Datas received
(PI2 Data reflec)
Prot. Interface OUT ON
OFF
**LEDBO
3227 >Prot Int 1: Transmitter is
switched off (>PI1 light off)
Prot. Interface SP ON
OFF
**LEDBIBO
3228 >Prot Int 2: Transmitter is
switched off (>PI2 light off)
Prot. Interface SP ON
OFF
**LEDBIBO
3229 Prot Int 1: Reception of faulty
data (PI1 Data fault)
Prot. Interface OUT ON
OFF
* * LED BO 93 135 1 Yes
3230 Prot Int 1: Total receiption failure
(PI1 Datafailure)
Prot. Interface OUT ON
OFF
* * LED BO 93 136 1 Yes
3231 Prot Int 2: Reception of faulty
data (PI2 Data fault)
Prot. Interface OUT ON
OFF
* * LED BO 93 137 1 Yes
3232 Prot Int 2: Total receiption failure
(PI2 Datafailure)
Prot. Interface OUT ON
OFF
* * LED BO 93 138 1 Yes
3233 Device table has inconsistent
numbers (DT inconsistent)
Prot. Interface OUT ON
OFF
**LEDBO
No. Description Function Type
of In-
for-
matio
n
Log Buffers Configurable in Matrix IEC 60870-5-103
Event Log ON/OFF
Trip (Fault) Log ON/OFF
Ground Fault Log ON/OFF
Marked in Oscill. Record
LED
Binary Inputs
Function Key
Relay
Chatter suppression
Type
Information Number
Data Unit
General Interrogation