Mounting and maintenance
4.5 Replacing individual components
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
127
4. Release the plug connector ① at the component to be replaced.
5. Release the plug connector ③ at the component to the right (if this is available).
6. Pull-up the slider
④ using a screwdriver ⑤.
7. Detach the component to be released from the lower edge of the standard mounting rail.
When doing this, ensure that both plug connectors are completely opened and in the
vertical position in order to release the interlocking between the modules.
To Next Page
Loading...
