Siemens SITOP PSU8600 - Reset to Factory Settings

Engineering and remote access
7.5 SIMATIC STEP 7
Power supply system SITOP PSU8600
224 Manual, 09.2018, A5E36758446-5-76
7.5.8
Reset to factory settings
A reset to the factory settings deletes all hardware and software configurations stored in the
SITOP PSU8600 and restores the factory settings.
This influences, for example:
● IP address
● Device name
● Parameter values for the SITOP PSU8600 and assigned supplementary modules
Proceed as follows to reset the SITOP PSU8600 to the factory settings:
1. Select "Target system-> Ethernet > Edit Ethernet node"
2. Click the "Browse" button in the "Edit Ethernet node" dialog to select the MAC address of
the SITOP PSU8600 where the factory settings should be restored.
3. Click on the "Reset" button.