Engineering and remote access
7.8 OPC UA server
Power supply system SITOP PSU8600
322 Manual, 09.2018, A5E36758446-5-76
HardwareManRemoteDipSwitch Boolean PropertyType REMOTE operating mode is se-
HardwareOperatingModeDipSwitch Boolean PropertyType Actual switch position operating
mode output 1 at the basic unit
constant current or electronic shut-
HardwarePriorityBufferedChan-
nel1DipSwitch
Boolean PropertyType Actual switch position for prioritized
buffering (PRIO) of output 1 at the
HardwareReservedDipSwitch
Actual state of input "RST"
HardwareStartupModeDipASwitch Boolean PropertyType Actual switch position for the sys-
tem switch-on behavior, dip
HardwareStartupModeDipBSwitch Boolean PropertyType Actual switch position for the sys-
tem switch-on behavior, dip
HardwareWebserver
Boolean PropertyType Web server is enabled MANUALLY
IdentificationDeviceNameSetpoint
IdentificationContactSetpoint
IdentificationLocationSetpoint String PropertyType Location
IdentificationPNLocationIDSetpoint
IdentificationPNPlantDesigna-
String PropertyType System designation
Note
Parameter "IdentificationPlantDesignationSetpoint" and "IdentificationLocationSetpoint" are
handled differently by the various S7 systems.
-1200 and S7-1500 correctly process the data sets.
-300, S7-400 and ET200SP do not fully support this data. Proceed as follows to correctly
save this data to these PLCs:
Write the data to identify the devices in the PLC code using function "WR_REC".
Read the data to identify the devices using "RD_REC".
For the ET200SP, a description of the two functions can be found here
(https://support.industry.siemens.com/cs/de/en/view/58649293
):
Alternatively, use the PRONETA
(
https://support.industry.siemens.com/cs/ww/en/view/67460624) tool to read and write
data
To Next Page
Loading...
