Siemens SITOP PSU8600 - Addressing (MAC Address); Overview of Application Examples

Engineering and remote access
7.2 Addressing (MAC address)
Power supply system SITOP PSU8600
170 Manual, 09.2018, A5E36758446-5-76
7.2
Addressing (MAC address)
In a network, the SITOP PSU8600 is addressed using its physical MAC device address. This
is printed on the front side of the basic device.
Further, the basic devices are equipped with a 2 port switch, which can also be identified
using the following MAC addresses in the network:
●
Ethernet port 1:
MAC address of the basic device + "1"
●
Ethernet port 2:
MAC address of the basic device + "2"
7.3
Overview of application examples
You can find the following application example for parameterizing the SITOP PSU8600
power supply system at our support website:
● Using graphic and communication blocks to integrate the SITOP PSU8600 into an
automation system (PSU8600 graphic and communication blocks
(https://support.industry.siemens.com/cs/ww/en/view/102379345
))
● Visualizing energy data of a SITOP PSU8600
(https://support.industry.siemens.com/cs/ww/en/view/109738082
)
● SIMATIC IPC - protection against power failures
(https://support.industry.siemens.com/cs/ww/en/view/109739384
)
● Ramping down an IPC with software controller while SITOP PSU8600 is in the buffering
mode (https://support.industry.siemens.com/cs/ww/en/view/109737962
)
● Integration and simulation of a SITOP 24 V power supply in SIMATIC PCS 7
(https://support.industry.siemens.com/cs/ww/en/view/109481908
)
● SIMATIC PCS 7 standard architectures ( V9.0 / V8.2 / V8.1 / V8.0 / V7.1 / V7.0)
(https://support.industry.siemens.com/cs/ww/en/view/32201963
)
Also visit the SITOP topic page
(https://support.industry.siemens.com/cs/ww/en/view/109748829
).