Siemens SITOP PSU8600 - Setting the Output Voltage; Setting the Response Threshold Value of the Output Current

Operator control at the device
3.1 Setting the output voltage and response threshold value of the output current
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
83
Assigning the potentiometers to the outputs for the 6EP4436-8XB00-0DY0 expansion
module:
①
Output number
②
Voltage potentiometer for two outputs
③
Current potentiometer for two outputs
3.1.1
Setting the output voltage
● Using a screwdriver, at the voltage potentiometer, set the notch on the inner ring to the
required value.
A setting 15 V is shown in the following diagram.
Value range: 4 to 28 Volt.
Factory setting: 24 Volt.
3.1.2
Setting the response threshold value of the output current
● Using a screwdriver, at the current potentiometer, set the notch on the inner ring to the
required value.
A setting of 2 A is shown in the following diagram.
Value range at the basic units depending on the type: 2 to 20 A or 4 to 40 A.
Value range at the expansion module depending on the type: 0.5 up to 2.5 A, 0.5 up to 5 A
or 0.5 up to 10 A.
Factory setting: relevant maximum value.