Siemens SITOP PSU8600 - Web Server

Engineering and remote access
7.7 Web server
Power supply system SITOP PSU8600
288 Manual, 09.2018, A5E36758446-5-76
3. Select the "Communication interface" entry.
4. In the editor area enter the system identifier, location ID and unit name.
5. To dynamically assign the IP address: Activate "DHCP".
6. To assign a fixed IP address: Activate checkbox "IP address" and enter the appropriate
parameters in the editor area.
7. Load the data to the device, see Section "Loading the configuration (commissioning)
(Page 277)".
7.7.7.3
Web server
Here, you can make general settings and define which actions should be automatically
executed. Here you can find the user administration.
Web server
Parameter
Value range
Default setting
Web server is enabled MANUALLY
Yes/no
No
Activate web server on this module
Yes/no
No
Permit access only with HTTPS
Yes/no
Yes
Log off automatically after 15 minutes Yes/no No
Update interval
0 / 5 s / 10 s / 20 s / 30 s / 60 s
10 s
●
Web server is enabled MANUALLY
Reflects the switch settings of DIP switch WEN ⑪, see Chapter "Activate the web server
for the MANUAL operating mode on the module (Page 98)".
●
Activate web server on this module
Define as to whether the device may be accessed via the web server.