Siemens SITOP PSU8600 - Operator Controls; Basic Units

Description, device design, dimension drawing
2.7 Operator controls
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
39
2.7
Operator controls
2.7.1
Basic units
There are two main operating areas at the SITOP PSU8600 basic unit.
● LED buttons
① and potentiometers (② and ③):
The potentiometers are used to set the output voltage and response threshold value of
the output current. The output is switched-on and switched-off using the button. The
button can be used to make a manual reset after an electronic overload shutdown.
● Special functions can be activated using the position of the DIP switches (
④ to ⑪, see
the magnifying glass in the diagram).
No.
Designation
Labeling
Function
①
LED button
"ON/OFF/RST"
Switches on and switches off the output, or resets the output
after an electronic shutdown; see Chapter "Switching an output
on and off (Page 84)" and "Overload shutdown and carrying out
a reset (Page 85)".
②
Voltage
potentiometer "U (V)"
Sets the voltage of the relevant output; see Chapter "Setting the
output voltage (Page 83)".
③
Current
potentiometer "I (A)"
Sets the response threshold of the output current; see Chapter
"Setting the response threshold value of the output current
(Page 83)".
④
DIP switch "REN" Switches over between the MANUAL mode – with setting and
operation at the device – and REMOTE mode with remote con-
trol via PROFINET; see Chapter "MANUAL and REMOTE
operating modes (Page 88)".