Engineering and remote access
7.4 SIMATIC STEP 7 in the TIA Portal
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
195
Loading the configuration to the SITOP PSU8600
For commissioning, you must load the project data that you created offline into the
connected SITOP PSU8600. This project data results from the configuration of the hardware,
networks and connections in SIMATIC STEP 7.
Initially, the complete project data is loaded. Only the changes are subsequently loaded.
● The project data is consistent.
● The Device name must be identical, offline and online.
● The SITOP PSU8600 is accessible online.
● The SITOP PSU8600 is located in the PROFINET IO system of an IO controller.
● The PG/PC is connected to the same network to which the SITOP PSU8600 and the IO
controller are connected. The interface of the PG/PC must be set to TCP/IP.
Note
Ensure that the article number of the SITOP
PSU8600 configured offline matches the article
number of the device connected online.
To Next Page
Loading...
