Siemens SITOP PSU8600 - Page 280

Engineering and remote access
7.7 Web server
Power supply system SITOP PSU8600
280 Manual, 09.2018, A5E36758446-5-76
The following operating data are displayed via the web server:
Submenu
Entries
Data
PSU8600
• PROFINET device name
• IP address
• MAC address
• Article number
• Serial number
• HW revision
• SW revision
Data about the device
General
• Operating state
• Operating mode
• Input voltage:
• System load current:
• Maximum system output
current
Data regarding the state
Buffering
(if there is least 1 buffer module
in the system, the menu scope
depends on the BUF type)
• Buffer component disabled
via control contact (only BUF
4 s/10 s and UPS module)
• Buffer component disabled
via control command
• Sufficient buffer readiness
(only BUF 4 s/10 s and UPS
module)
• System charge status [%]
(only BUF 4 s/10 s and UPS
module)
• Current total charging power
[W]
Data regarding buffering
Output 1
See Outputs (Page 281)
Submenu
Entries
Data
UPS8600
• Article number
• Serial number
• HW revision
• SW revision
Data about the device
• Operating state
• Battery status
• Maximum permitted charg-
ing power
• Charging power [W]
• Charge status [%]
Data regarding the charge sta-
tus