Siemens SITOP PSU8600 - Page 326

Engineering and remote access
7.8 OPC UA server
Power supply system SITOP PSU8600
326 Manual, 09.2018, A5E36758446-5-76
Display name
Data type
Definition
Description
Alarm_MD_ChannelOverload
Boolean
Sitop_8600_AlarmType
Overload detected at the output
Alarm_MD_ChannelOvertempera-
ture
Boolean Sitop_8600_AlarmType Advance warning against overheat-
ing at output.
Alarm_MR_ChannelOverload Boolean Sitop_8600_AlarmType The actual value of the output
current is above the set advance
warning threshold.
Alarm_MR_ChannelStateBuffered
Off
Boolean Sitop_8600_AlarmType Output switched off during buffer-
ing
Alarm_MR_ChannelStateCurrent
LimitOperation
Boolean Sitop_8600_AlarmType Current limit on the output after
occurrence of an overload
Alarm_MR_ChannelStateReadyFor
Restart
Boolean Sitop_8600_AlarmType Output is ready to be switched on
Alarm_N_ChannelOutputTurnedOff
Boolean
Sitop_8600_AlarmType
Output was switched off.
Alarm_N_ChannelOutputTurnedOn
Boolean
Sitop_8600_AlarmType
Output was switched on.
Alarm_N_ChannelStateManualOff
Boolean
Sitop_8600_AlarmType
Output was switched off manually.
Alarm_N_SetpointParameterOutOf
Range
Boolean Sitop_8600_AlarmType Parameter out of permissible value
range.
HardwareSettings
Display name
Data type
Definition
Description
HardwareCurrentLimitPotentiome-
ter
Float AnalogItemType Manually set response threshold
HardwareOutputEnableButton Boolean PropertyType Output switched off manually (but-
ton):
HardwareTargetVoltagePotentiom-
eter
Float AnalogItemType Manually set setpoint of the output
voltage.
RemoteTargetValues
Display name
Data type
Definition
Description
CurrentLimitManToRem
Method
-
Set response threshold
CurrentLimitSetpoint Float AnalogItemType Response threshold of the output
current
CurrentThresholdSetpoint Byte AnalogItemType Prewarning threshold output cur-
rent
OutputEnableSetpoint
Boolean
PropertyType
Switch on output
OutputOperationModeSetpoint Byte MultiStateDiscrete-
Type
Operating mode
OutputReset
Method
-
Reset
StartupDelaySetpoint
UInt16
AnalogItemType
On delay
TargetVoltageManToRem Method - Accepts the manually set output
voltage setpoint in the remote set-
ting
TargetVoltageSetpoint
Float
AnalogItemType
Setpoint output voltage