Siemens SITOP PSU8600 - Page 376

Troubleshooting
8.3 Alarm list web server
Power supply system SITOP PSU8600
376 Manual, 09.2018, A5E36758446-5-76
ID
Severity
Event
Help text
124 F Invalid internal supply voltage. Voltage of the internal supply is too high. All outputs of the
power supply system have been switched off.
125 F Faulty communication to the mo-
dule.
Communication with the expansion module is faulty. All
outputs on the expansion module have been switched off.
126 F Critical error A critical error occurred. All outputs of the power supply
(module/system) have been switched off.
127 MD Critical error General critical error occurred. The device may therefore
behave inconsistently.
128 MR General error. General error occurred. Device behavior remains consistent,
however.
129 F Performing firmware update. Performing firmware update. Read/write access is currently
not possible.
130 F Stored module configuration cor-
rupt
Stored module configuration is corrupt. The module cannot
start up correctly.
131 MD Stored module configuration cor-
rupt
Stored module configuration is corrupt. Deviating module
behavior may be possible.
132 MR Stored module configuration cor-
rupt
Stored module configuration is corrupt. Module behavior
remains consistent, however.
133 F Hardware failure A hardware failure has occurred. All outputs of the power
supply system have been switched off.
134
N
Different firmware version detected
Different firmware version detected
135 MR New unconfigured module detect-
ed.
New unconfigured module detected.
136
N
Different serial number detected
Different serial number detected
137 MR Module with excessive power de-
tected.
A module with excessive power was detected. Normal oper-
ation of the system is possible.
138
MR
Unexpected module type detected.
Unexpected module type detected.
139 MD Module with reduced power de-
tected.
A module with reduced power was detected. Deviating sys-
tem behavior may be possible.
140 F Incompatible module detected. The module has a module type that is incompatible with the
configuration. The module cannot be commissioned.
141
F
Unexpected empty slot detected.
Unexpected empty slot detected.
142 F Output has been shut down be-
cause of a class 2 exception.
Output has been shut down because of a class 2 exception.
143 F Output has been shut down be-
cause of a class 2 exception.
Output has been shut down because of a class 2 exception.
144 F Output has been shut down be-
cause of a class 2 exception.
Output has been shut down because of a class 2 exception.
145 F Output has been shut down be-
cause of a class 2 exception.
Output has been shut down because of a class 2 exception.
146 F Output has been shut down be-
cause of a class 2 exception.
Output has been shut down because of a class 2 exception.
147 F Output has been shut down be-
cause of a class 2 exception.
Output has been shut down because of a class 2 exception.
148 F Output has been shut down be-
cause of a class 2 exception.
Output has been shut down because of a class 2 exception.