Operator control at the device
3.7 Setting the on delay
Power supply system SITOP PSU8600
96 Manual, 09.2018, A5E36758446-5-76
With the power supply system shut down, bring both DIP switches "STDA" and "STDB" into
position "OFF" (left), to deactivate on delay.
With the power supply system shut down, bring DIP switch "STDA" into position "ON" (right)
and "STDB" into position "OFF" (left) in order to set the on delay to 25 ms.
With the power supply system shut down, bring DIP switch "STDA" into position "OFF" (left)
and "STDB" into position "ON" (right) in order to set the on delay to 100 ms.
With the power supply system shut down, bring both DIP switches "STDA" and "STDB" into
position "ON" (right) to activate load-optimized on delay.
To Next Page
Loading...
