Operator control at the device
3.9 Activate the web server for the MANUAL operating mode on the module
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
99
Deactivating the web server
Bring DIP switch "WEN" into the "OFF" position (left) to deactivate the web server integrated
in the module.
Activating the web server
Bring DIP switch "WEN" into the "ON" position (right) to activate the web server integrated in
the module.
Note
No write access when the connection is active
If the SITOP PSU8600 has an active connection to a control system (relation application),
then the parameters can only be read
-accessed. It is still possible to update the firmware -
and save and delete the alarm list. If there is no active connection, then parameters can also
be write accessed via the web server.
Note
After the system is switched on for the first time with activated web server, the power supply
system generates
an SSL certificate to access the web server.
Wait for approximately two minutes until the SSL certificate has been generated and access
to the web server has been activated.
You can find additional information about the integrated web server in Chapter "Web server
(Page 270)".
To Next Page
Loading...
