Siemens SITRANS LUT400 Series - Page 350

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 37
mmmmm
Commissioning
3. Editing in PROGRAM mode
Selecting a listed option
a. Navigate to the desired parameter.
b. Press RIGHT arrow to open Edit
mode. The current selection is
highlighted.
c. Scroll to a new selection.
d. Press RIGHTarrow to accept it.
The LCD returns to parameter view and
displays the new selection.
Changing a numeric value
a. Navigate to the desired parameter.
b. When selected, the current value is
displayed.
c. Press RIGHT arrow to open Edit
mode. The cursor position is highlighted.
d. Use LEFT and RIGHT arrow to
move cursor to digit position you wish to
change.
e. As each digit is highlighted (selected),
use the UP and DOWN arrow to increase or decrease the digit
respectively.
f. While decimal point is selected, use UP and DOWN arrow to shift decimal
position.
g. To escape without saving your changes, press LEFT arrow continually until ESC
is highlighted. Press LEFT arrow again to escape without saving changes.
Otherwise, when new parameter value is correct, press RIGHT arrow
continually until OK is highlighted.
h. Press RIGHT arrow to accept the new value. The LCD returns to parameter
view and displays the new selection. Review for accuracy.
Key functions in Edit mode
Key Name Function
UP or
DOWN
arrow
Selecting
options
Scrolls to item.
Alpha-
numeric
editing
- Increments or decrements digits
- Toggles plus and minus sign
SENSOR
2.1.6
UNITS
SENSOR MODESECONDARY
TRANSDUCER
FREQUENCY
XRS-5
SENSOR MODE
TRANSDUCER
2.1.6
NO TRANSDUCER
XPS-10
XPS-15
XCT-8
XCT-12
XPS-30
XRS-5
parameter
name
parameter
number
current
value
menu
name
CALIBRATION
2.2.1
LOW CALIB. PT.
SENSOR OFFSET
NEAR RANGE
FARRANGE
2.00 M
HIGH CALIB.PT.
LOW CALIB. PT.
2.2.1
ESC
+______
OK02.
M
current
value
parameter
number
parameter
name