Siemens SITRANS LUT400 Series - Page 353

Page 40 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS 7ML1998MV01
mmmmm
Commissioning
Start of QS Level Wizard
Shows the type of Wizard to be executed.
Transducer
Specifies the Siemens transducer connected to the device.
Operation
Sets the type of measurement (and the corresponding mA output) required for the
application.
Note: The introduction screen is displayed only on the device when using the local
push buttons. This screen is not part of the Quick Start when using SIMATIC PDM.
Options
CANCEL, START
Options
NO TRANSDUCER, XRS-5, XPS-10, XPS-15, XCT-8, XCT-12, XPS-30, XPS-40,
XLT-30, XLT-60, STH
Default: NO TRANSDUCER
Start of QS
Level Wizard
Select transducer
Select operation
Select temperature
source
Set level units and
setpoints
Level Wizard
complete
- Transducer
- Operation
- Temperature Source
- Fixed Temperature
- Units
- High Calibration Point
- Low Calibration Point
- Response Rate
sensor reference point
level
Low Calibration Point
High Calibration Point
distance
space
Far Range