Siemens SITRANS LUT400 Series - Page 360

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 47
mmmmm
Commissioning
1.1.3. QS Flow
Use this wizard to configure simple flow applications.
(Visible on LUT430 (Pump and Flow), and LUT440 (OCM) configured models only.
a. Press RIGHT arrow to activate PROGRAM mode and open menu level 1: MAIN
MENU.
b. Press RIGHT arrow two times to navigate to menu item 1.1.1.
c. Press DOWN arrow two times and RIGHT arrow to open QS Flow.
d. At each step, press DOWN arrow to
accept default values and move directly to
the next item,
or RIGHT arrow to open Edit mode: the
current selection is highlighted.
e. Scroll to desired item and press RIGHT arrow
to store the change, then press DOWN
arrow to continue.
f. At any time, you can press UP arrow to
go back, or LEFT arrow to cancel the wizard.
QUICK STARTFLOW
TRANSDUCER
XRS-5
NEXT
BACK
EDITCANCEL
QUICK STARTFLOW
NO TRANSDUCER
XPS-10
XPS-15
XCT-8
XCT-12
XRS-5
TRANSDUCER
Start of QS
Flow Wizard
Select
transducer
Select
temperature
source
Select
PMD
Set
calculation method,
level units, and
setpoints
Set
calculation factors
(vary by PMD)
Set
PMD dimensions
(vary by PMD)
Set
flow units and
calibration data
Flow Wizard
complete
- Transducer
- Temperature Source
- Fixed Temperature
- Primary Measuring
Device
- Method of Flow
Calculation
- Units
- High Calibration Point
- Low Calibration Point
- Response Rate
- Flow Exponent
- K Factor
- V-Notch Angle
- Slope
- Roughness Coefficient
- OCM Dimension 1
- OCM Dimension 2
- OCM Dimension 3
- OCM Dimension 4
- Maximum Head
- Zero Head Offset
- Flowrate Units
- Maximum Flow at 20 mA
- Flowrate Decimal
- Low Flow Cutoff