Page 158 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS A5E33329501
mmmmm
Parameters
2.7.2.2.13. Peak ON Setpoint Pump 1
Sets the process point at which Pump 1 will turn on when in a peak
period.
To allow the level to go beyond the normal Relay ON Setpoint before
a pump is started, enter the value to be used for the high-energy
cost period.
2.7.2.2.14. Peak OFF Setpoint Pump 1
Sets the process point at which Pump 1 will turn off when in a peak
period.
To stop the pump(s) before the normal relay OFF Setpoint and
reduce pump-running time. Enter the value to be used for the high
cost period.
2.7.2.2.15. Peak ON Setpoint Pump 2
Sets the process point at which Pump 2 will turn on when in a peak
period.
To allow the level to go beyond the normal Relay ON Setpoint before
a pump is started, enter the value to be used for the high-energy
cost period.
2.7.2.2.16. Peak OFF Setpoint Pump 2
Sets the process point at which Pump 2 will turn off when in a peak
period.
To stop the pump(s) before the normal relay OFF Setpoint and
reduce pump-running time. Enter the value to be used for the high
cost period.
Values
Range: 0.000 to 99999.000
Default: 0.000
Values
Range: 0.000 to 99999.000
Default: 0.000
Values
Range: 0.000 to 99999.000
Default: 0.000
Values
Range: 0.000 to 99999.000
Default: 0.000
To Next Page
Loading...
