Siemens SITRANS LUT400 Series - Page 514

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 201
mmmmm
Parameters
3.1.8. Serial Number
Read only. Unique factory set serial number of the device.
3.1.9. Final Assembly Number
Integer used to identify the device on site, e.g. enter ’2’ to denote second
SITRANS LUT400 in application.
3.1.10. Hardware Revision
Read only. Corresponds to the electronics hardware of the Field Device.
3.1.11. Firmware Revision
Read only. Corresponds to the software or firmware that is embedded in the
Field Device.
3.1.12. Loader Revision
Read only. Corresponds to the software used to update the Field Device.
EDD Version
Read only. Corresponds to the Electronics Device Description (EDD) installed
with the device.
3.1.13. Manufacture Date (Date of Manufacturing in PDM)
The date of manufacture of the SITRANS LUT400 (YYYY-MM-DD).
3.1.14. Order Option
Read only. Displays the device type: Standard or NAMUR 43-compliant.
3.2. Diagnostics
3.2.1. Echo Profile
Allows you to request the current echo profile either locally via the local push
buttons, or remotely via SIMATIC PDM.
To request a profile via the local push buttons:
a) In PROGRAM mode, navigate to MAIN MENU > DIAGNOSTICS (3) >
ECHO PROFILE (3.1)
b) Press RIGHT arrow to request a profile.
For more detail see
Requesting an Echo Profile on page 57.
For more details on how to interpret an Echo Profile, see Echo Processing on
page 257.
Note: Default settings in the parameter tables are indicated with an asterisk (*)
unless explicitly stated.
Note: An Echo Profile (3.2.1.) cannot be requested from LUI when:
• Transducer Enable (3.3.1.) is set to DISABLED,
or when
• Transducer (2.1.6.) is set to NO TRANSDUCER.
In either case, the local push button will not operate.