Siemens SITRANS LUT400 Series - Page 591

Page 278 SITRANS LUT400 (HART) – INSTRUCTION MANUAL SITRANS LUT400 (HART) – INSTRUCTION MANUAL A5E33329501
Appendix C: menu chart
LCD Menu Structure
MAIN MENU
1. WIZARDS
1.1 QUICK START
1.1.1 QS LEVEL
INTRODUCTION
TRANSDUCER
OPERATION
TEMPERATURE SOURCE
FIXED TEMPERATURE
UNITS
HIGH CALIB. PT.
LOW CALIB. PT.
RESPONSE RATE
APPLY?
1.1.2 QS VOLUME
INTRODUCTION
TRANSDUCER
TEMPERATURE SOURCE
FIXED TEMPERATURE
VESSEL SHAPE
UNITS
HIGH CALIB. PT.
LOW CALIB. PT.
RESPONSE RATE
DIMENS. A
DIMENS. L
VOLUME UNITS
MAX. VOLUME
APPLY?
1.1.3 QS FLOW (LUT430, 440 only)
INTRODUCTION
TRANSDUCER
TEMPERATURE SOURCE
FIXED TEMPERATURE
PRIMARY MEASURING DEVICE
METHOD OF FLOW CALCULATION
UNITS
HIGH CALIB. PT.
LOW CALIB. PT.
RESPONSE RATE
Calculation factors (vary per PMD)
PMD dimensions (vary per PMD)
MAXIMUM HEAD
ZERO HEAD OFFSET
FLOWRATE UNITS
MAXIMUM FLOW AT 20MA
FLOWRATE DECIMAL
LOW FLOW CUTOFF
APPLY?
1.2 PUMP CONTROL
INTRODUCTION
NUMBER OF PUMPS
RELAY PUMP 1
RELAY PUMP 2
PUMP CONTROL MODE
SERVICE RATIO PUMP 1
SERVICE RATIO PUMP 2
RUN TIME PUMP 1
RUN TIME PUMP 2
ON SETPOINT PUMP 1
ON SETPOINT PUMP 2
OFF SETPOINT PUMP 1
OFF SETPOINT PUMP 2
2. SETUP
2.1 SENSOR
2.1.1 UNITS
2.1.2 SENSOR MODE (LUT420)
2.1.3 SENSOR MODE (LUT430, 440)
2.1.4 SENSOR MODE SECONDARY (LUT420)
2.1.5 SENSOR MODE SECONDARY (LUT430, 440)
2.1.6 TRANSDUCER
2.1.7 FREQUENCY
2.1.8 LONG SHOT DURATION
2.1.9 SHORT SHOT DURATION
2.2 CALIBRATION
2.2.1 LOW CALIB. PT.
2.2.2 HIGH CALIB. PT.
2.2.3 SENSOR OFFSET
2.2.4 NEAR RANGE
2.2.5 FAR RANGE
2.2.6 AUTO SENSOR OFFSET
2.3 RATE
2.3.1 FILL RATE/MIN
2.3.2 EMPTY RATE/MIN
2.3.3 DAMPING FILTER
2.4 FAIL-SAFE
2.4.1 MATERIAL LEVEL
2.4.2 LOE TIMER
2.4.3 FAIL-SAFE MA VALUE
2.5 CURRENT OUTPUT
2.5.1 CURR. OUT. FUNC. (LUT420)
2.5.2 CURR. OUT. FUNC. (LUT430, 440)
2.5.3 4 MA SETPOINT
2.5.4 20 MA SETPOINT
2.5.5 MIN. MA LIMIT
2.5.6 MAX. MA LIMIT
2.5.7 MANUAL VALUE
2.5.8 CURRENT OUTPUT VALUE
2.6 VOLUME
2.6.1 VESSEL SHAPE
2.6.2 VOLUME UNITS
2.6.3 MAX. VOLUME
2.6.4 DIMENS. A
2.6.5 DIMENS. L
2.6.6 USER DEFINED UNIT
Notes:
•In Navigation mode ARROW keys navigate the menu in the
direction of the arrow.
•See
Parameter reference (LUI) on page 137 for detailed
information and instructions.
1. WIZARDS (cont’d)