Siemens SOMATOM Manual&Nbsp;

452
Specials
• Screen layout
In the interventional Toolbar for CARE Vision you can
change the Layout of the Display. There are three dif-
ferent modes available.
– Blow up (one big image)
– CARE View (three equal sized images)
– CARE View Blow up (one big and two smaller
images on each side)
If you choose certain slice thicknesses and collimations
in the Routine subtask card which are marked in bold
letters, you will get in addition to your center an image
that will be towards the head and one towards the
feed. Then you can use the CARE View and CARE View
Blow up mode as well for your interventional proce-
dure.
You can change these modes while you are in the
loaded process or while you are not applying radiation,
the layout changes will be applied if you start scan-
ning.
In the Interventional Toolbar for Biopsy you can
change the layout of the display. There are three differ-
ent modes available:
– Blow up (one big image)
–Two segment
– CARE View (three equal sized images)
The Image Layout can be changed in the interventional
Toolbar regardless of the chosen slice thickness or col-
limation from Blow-up Mode to the two segment
Mode. If you choose certain slice thicknesses and colli-
mations, which are marded in bold letters, you have
the option to get the images displayed in the CARE
View Mode as well.
The changes will be applied directly during the Biopsy
porcedure.

Siemens SOMATOM Specifications

General

Category	CT Scanner
Rotation Time	0.25 seconds
Tube Voltage	70-150 kV
Bore Size	78 cm
Max Table Load	250 kg
Gantry Aperture	78 cm
Table Weight Capacity	250 kg
X-ray Tube Voltage	70-150 kV
Scan Time per Rotation	0.25 seconds
Software	Syngo
Connectivity	DICOM