SIGLENT SDM3045X - To Measure Period

SIGLENT
SDM3045X Digital Multimeter 29
To Measure Period
Operating Steps:
1. Press and on the front panel and select 【Period】to enter
the Period measurement interface. The lower right corner of the screen
shows the unit of Period, as shown in Diagram 2- 21.
Diagram 2- 21 Period Measurement Interface
2. Connect the red lead to terminal Input-HI and black lead to terminal
Input-LO as the following diagram.
Diagram 2- 22 Sketch Map for Measuring Period
3. Choose a proper voltage range according to the measured circuit.
Table 2- 9 Measurement Characteristics of Period
Ranges
200mV, 2V, 20V, 200V, 750V
Measurement Range
2μs – 50ms
Input Protection
750Vrms on all ranges (HI terminal)
Configurable
Parameters
Range, Rel