SIGLENT
SDM3045X Digital Multimeter 31
To Test Continuity
Continuity test uses double leads method to measure the resistance of the
measured circuit via about 0.5mA current. When the measured resistance in
circuit is lower than the selected one, it is considered being connected with
instrument. The method to test Continuity will be introduced in details as the
following steps.
Operating Steps:
1. Press on the front panel to enter the Continuity test interface, as
shown in Diagram 2- 23.
Diagram 2- 23 Continuity Measurement Interface
2. Connect the red lead to terminal Input-HI and black lead to terminal
Input-LO as the following diagram.
Diagram 2- 24 Sketch Map for Testing Continuity
3. Set the Short-circuit resistance.
To Next Page
Loading...
