94
TO MARK A SINGLE IMAGE
1
Use the arrows on the 4-way controller
to select the image to be marked in Contact
Sheet or Single-Image View.
2
Press to display the Modification Menu.
3
Use the arrows on the 4-way controller to
select the Mark Menu.
4
Use the arrows on the 4-way controller to
select “Mark”.
• If the selected image is already marked, the
“Mark” menu item will change to “Unmark”.
5
Press
to mark the image. A flag icon
will appear in the upper-right corner of the
image indicating that the image is marked.
TIP
• To unmark a marked image, select the marked image and follow the same
steps as above.
• If the Mark Menu was opened from Jump Mode, the “Mark” menu item will
not be available.
• The
button can be used as a shortcut key for marking images. (See
P.98)
To Next Page
Loading...
