4100U-S1 Programming Guide Document: LT0400
Adding Addressable Devices
Page 5-6 15 December 2010 Issue 1.4
Select the MAPNET/IDNet option
All available addressable devices
(MAPNET, IDNet, etc) will now be listed in
the Tag List window.
Select the required devices by highlighting
the device and pressing the <SPACEBAR>.
Two red chevrons “>>” indicate the device
has been tagged.
Press OK when all devices are tagged
for this zone.
Note: If a point is inadvertently un-tagged, it might be necessary to use the Filter function to
find the appropriate point to re-tag it back into the Zone List, e.g. if L261 ALARM LIST ZONE
1 has lost its ALARM TEST ZONE 1 digital point, the filter function can be used to find and
retag the User Digital Pseudo P1001.
To Next Page
Loading...
Need help?
General
