Document: LT0400 4100U-S1 Programming Guide
Adding Expansion Modules
Issue 1.4 15 December 2010 Page 8-11
Click the Port Data… button and select the
desired Device Type as in the following
example for an 80 column CRT output.
Click OK and again for the previous screen.
Repeat for Port B (if used) and select the
appropriate device type and baud rate, etc.
Note: Only Port A can be used for
modems or 2120 interface. Either Port
can be used for printers or terminals
8.7.1 Typical Printer Configuration:
Depending on the printer, the usual settings are:
Device type PRT80U
Baud rate 9600
Parity None
Data bits 8
Stop bits 1
Printer Cable Connections
To Next Page
Loading...
Need help?
General
